Angelo Po 091CP1E Use And Installation Manual page 29

Quick automatic top-up.
– Turn the knob (B) to 2 to fill the well to the maxi-
mum level automatically when the water level
drops below the minimum threshold. The maxi-
mum and minimum levels refer to the operating
range of the pressure switch that controls the wa-
ter supply.
Slow automatic top-up.
– Turn the knob (B) to 3 for a slow, continuous flow
of water that keeps the water level inside the well
constant.
Important
If the water drops below the minimum level,
the "quick automatic top-up" mode is auto-
matically triggered.
Emptying
4 - Turn the knob (B) to 4 to shut off the water sup-
ply.
5 - Turn on the tap (C) to empty the well.
RESETTING THE APPLIANCE
If the safety thermostat is tripped, the appliance has
to be restored to the initial working conditions as fol-
lows.
1 - Allow the water to cool by 30-40°C
2 - Open the hatch (A).
3 - Press the button (B) of the safety thermostat to
restore the electricity supply.
4 - Close the door (A) when the operation is com-
plete.
LENGTHY DOWNTIMES OF APPLIANCE
If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Cut off the mains electricity supply using the ap-
pliance's master switch.
2 - Clean the appliance and the surrounding areas
thoroughly.
C
Important
The water drained from the appliance must
pass through a suitable drain line, resistant
to a temperature of at least 100°C.
The steam produced when the well is
drained must not come into contact with
the appliance (see also connection dia-
gram at back of manual).
B
3 - Spread a film of edible oil over the stainless
steel surfaces.
4 - Carry out all the servicing procedures.
5 - Leave the appliance uncovered and the cook-
ing chambers open.
- 9 -
IDM-39615600800.tif
IT
GB
DE
A
IDM-39615600900.tif
FR
ES
English