Georeference Page - FLIR Elara DX Series Installation And User Manual

Hide thumbs

Table Of Contents

Table of Contents

Operation

Washer device installed—If you have installed an optional wash kit, click On. To apply changes to

this setting, the camera needs to reboot.

When On is selected, the following washer controls are

available:

Washer

o Start—Turns the washer on for the amount of time specified

for the wash spray duration below. If the camera's pan and tilt

is not in the washer position, the camera moves to the

washer position. If the washer position has not been defined,

define one.

o Finish—Turns the washer off. If the camera's pan and tilt is in

the washer position, the camera moves back to its previous

position.

Advanced Settings

Washer Position

o PTZ controls—Moves the camera. Set the washer position

so that the washer sprays liquid over both camera lens windows.

o Go To—Moves the camera to its washer position (if defined).

o Set—Sets the camera's current pan and tilt as its washer position.

Wash Spray Duration—Specify the amount of time the washer turns on when you click Start under

Washer, between 0-10 seconds.

Important

If a wash kit is connected to the camera's Alarm-Out A1 and A2 pins on the 14-pin terminal block

connector, these washer controls activate it through local output 1 (see

another device is connected to the Alarm-Out A1 and A2 pins, the washer controls affect that device.

If no device is connected to Alarm-Out A1 and A2, these controls only affect the camera's pan and tilt

position (if a washer position is defined). For more information, see

Wash

Kit.

3.11