Technogel MANTE 15-45 Instruction For Installation, Usage And Maintenance page 51

Machine positioning with air cooling
It is most important to position the machine in a roomy environment w ith doors and w indow s to
facilitat e ventilation of the heated air.
The rear of the machine must be at least 0.5 metres from the w all.
During machine operation the doors and w indow s of the room must be kept open otherw ise the air
heated by the machine w ill become extremely hot reaching a temperat ure as high as 50° C. If the
machine operates in heated condition for long periods the machine' s main components (refrigeratior
compressor and turbine motor) w ill overheat to such an extent that t he machine' s operation w ill be
adversely affected. This w ill lead t o bad performance and t hus unneceesary expense and cost. In
addition excessive heat w ill increase electricity consumption and yield may fall to below 50% .
IDEAL POSITIONING OF THE MACHINE
As can be seen in the diagram, the air entering through door (1) is sucked in and heated during
condensation from the ventilators (2). It is then pushed tow ards the w indow (3) from w hich it exits .
Though not alw ays practical, the ideal solution solution is to make holes in t he w all (4), corresponding
to the ventilators (2). This w ill let the air exit freely w ithout impediment s thus ensuring a consistently
optimum yield from the machine.
TECHNOGEL spa CANNOT ASSUME ANY RESPONSIBILITY FOR DAMAGE CAUSED BY
POSITIONING THE MACHINE IN UNSUITABLE ENVIRONMENTS. IN ADDITION
TECHNOGEL IS NOT RESPONSIBLE FOR FALLS IN MACHINE YIELD CAUSED BY
OPERATING UNDER LIMITING CONDITIONS.
51