Management ports
Management is provided using either the 10/100/1000
Megabits per second (Mb/sec.) base T Ethernet port
accessible from the RJ-45 connector or the RS-232
management port with a back panel accessible RJ-11
interface.
Exhibit 1.1-1 FastStream SC main board layout.
3
ATTO Technology Inc. FastStream SC RAID Controller Installation and Operation Manual
Manual reset switch
A manual reset switch reboots the storage controller.
To reset the FastStream, depress the reset button for
no more than three seconds.
To restore factory defaults, press the reset button for
more than four seconds until the green Ready LED
blinks.
LED
A bicolor LED on the back panel shows unit status:
when green, the unit is in the Ready condition and is
fully operational; if it is lit yellow, a fault has been
detected and you should begin troubleshooting
procedures.