Atto Faststream Embedded Components; Board Dimensions; Temperature; Humidity - ATTO Technology FastStream SC 5500E Installation And Operation Manual

1.1 ATTO FastStream Embedded Components

The ATTO FastStream Fibre Channel to SAS/SATA RAID controller line can be seamlessly integrated into an ATX
or custom storage enclosure.
ATTO FastStream SC RAID controllers support next-
generation media and are equipped to handle the
throughputs needed by advanced disk technologies.
For installation instructions, refer to
FastStream on page 10.

Board dimensions

The FastStream SC embedded storage controllers
feature MicroATX-size printed circuit boards (PCB).
The boards can be used in enclosures that have
adequate clearance for the DIMM socket and
allowance for connecting to internal connectors.
Width: 7.0 in. ± 0.005 in. (17.78 cm ±0.01 cm)
Length: 9.6 in. ± 0.005 in. (24.38 cm ±0.01 cm)
Height: 1.3 in. ± 0.005 in. (3.3 cm ±0.01 cm)

Temperature

Non-operating: -40 ºC to +70 ºC
Operating: +5 ºC to +40 ºC

Humidity

Non-operating: 5% to 95% non-condensing
Operating: 10% to 90% non-condensing

Altitude

Non-operating: 50,000 feet (15,240 meters)
Operating: 10,000 feet (3048 meters)

ESD

Contact discharge: Up to ±8kV no errors
Air discharge: Up to ±15kV no errors

Real Time Clock

The Real Time Clock uses an M41T0 from ST
Microelectronics. The contents are maintained
regardless of power cycles. A rechargeable 3V Lithium
ion battery provides up to 90 days of backup power.
The charger is integrated on the circuit board. The
Lithium ion battery may explode if mistreated.
Install the

Power supply requirements

A stable power source is necessary for proper and
reliable operation. The FastStream is compatible with
ATX power supplies with a 24-pin ATX connector and
requires +12V, (±10%) 6A for proper operation.

SAS/SATA ports

The eight independent
SAS/SATA ports use
internal wide-SAS Small
Form Factor (SFF) 8484
connectors to connect to
either SAS or SATA
devices.

Fibre Channel ports

SC 7500 and 8500: four independent Fibre Channel
ports connect to Fibre Channel hosts.
SC 5500: two independent 4-Gigabit Fibre Channel
ports to connect to Fibre Channel hosts.
All models use optical SFP connectors and multimode
fiber optic cable.
Make sure all cables are anchored securely at both
ends with the proper connectors.
WARNING
WARNING
To prevent shorting, premature failure or
damage to the battery, do not place the
board on a conductive surface such as
metal, black conductive foam or the
outside surface of a metallized ESD
protective pouch with your local
environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
2