ATTO Technology FastStream SC 5500E Installation And Operation Manual page 16

The internal SAS physical interface consists of
the 32-pin SFF-8484 connectors. The internal
cable can be unshielded and should terminate
from the SFF-8484 connector in the enclosure.
a. Plug in the corresponding end of the
internal SAS cable to the FastStream SC
internal SAS connector (port A and/or port
B).
b. Plug in the opposite end of the internal SAS
connector to the corresponding connector
of the enclosure backplane or SAS/SATA
peripheral.
9 Attach a management interface cable.
You may manage the FastStream using either
an RJ-45 Ethernet cable or an RJ-11 serial
cable.The preferred management tool is the
ExpressNAV graphical user interface accessed
through the Ethernet cable.
RJ-45 Ethernet cable: A board-mounted RJ-45
connector at the back I/O panel connects with a
10/100/1000 baseT category 5 or 6 Ethernet
cable. If using an Ethernet network at 1000
baseT, use a category 6 cable to make the
connection. The FastStream ships with Cat 5
cable.
Exhibit 2.0-1 FastStream SC RAID controller components, dimensions and mounting holes. For pinout
information, refer to Reference Charts
11
ATTO Technology Inc. FastStream SC RAID Controller Installation and Operation Manual
a. Align the tab on the Ethernet cable with the
b. Insert the cable until it positively mates and
RJ-11 serial cable: A board-mounted RJ-11
cable at the back I/O panel makes connection
with an RS-232 serial port for appliance
management.
a. Align the tab on the provided serial cable
b. Insert the cable until it positively mates and
c. Insert the other end of the serial cable into
10 Install drives into your enclosure according to
the enclosure and drive manufacturers'
instructions.
11 Put the cover back on the enclosure.
12 Power up the unit.
on page xxiv of the Appendix.
tab on the Ethernet port of the FastStream.
locks into place.
with the tab on the RJ-11 serial port of the
FastStream
locks into place.
the DB9 port of the PC being used for
appliance control.
1 PCI-e connector (J10)
2 RJ11 serial port connector (J3)
3 RJ-45 Ethernet connector (J2)
4 ATX 24-pin power connector (J1)
5 Vertical SDRAM DIMM connector
6 ATX power switch header (P3)
7 Intel 81348 storage processor
8 Internal SAS Port A connector (J9)
9 Internal SAS Port B connector
(J11)
10 Momentary reset pushbutton
11 Back panel ready/fault LED
Mounting holes are labeled C, F, H,
J, L and M.