Vermiculite Panel Replacement; Stone ( If Equipped ); Ceramic Panels ( If Equipped ) - HearthStone Bari 8171 Installation And Operating Instructions Manual

V P
ERMICULITE ANEL
1. Tilt top into firebox, and remove the panel.
2. To remove the upper panel, push up on the panel,
locate the front securing bracket, tilt the bracket
to the front of the stove, push the bracket up into
its mounting slot, Drop down the upper panel.
3. Install the side panels by placing each one into
the right position and then tilt the panels back into
place All side panels are identical.
4. Push side panels together tightly and center them
so the spaces along the front edges are equal,
5. To install the upper panel, insert the panel rear
edge first into the space below the baffle plate –
hold in place and insert the securing bracket
which hangs down from the top of the firebox.
S (
TONE IF EQUIPPED
The stone panels on this stove are large and heavy
(150 pounds total). Use a second person to assist in
mounting the panels to avoid injury, or damaging the
panels. Despite the mass of each piece of soapstone,
they will break if dropped. See the Stone Install
Instructions included with the Stone Kit.
Occasional cleaning is all that is necessary to
maintain the natural beauty of your stove's soapstone
Hearthstone Quality Home Heating Products, Inc ®
R :
EPLACEMENT
)
finish. The soapstone pieces have a smooth,
unpolished surface, and will absorb liquids applied to
them. Clean the soapstone only with water, or any
non-abrasive glass cleaner and a soft cloth. Wipe
dust from the stone with a clean cloth. To avoid
staining, do not use chemical agents to wash the
stone; do not use waxes or any polishing agents on
the stone.
Take care not to scratch or chip the soapstone. Do
not set items that can scratch or chip the stone on top
of your stove. You can use 240 grit sandpaper to
easily repair, or blend in minor scratches
Often, with use and over time, subtle earth tones of
brown, green, red, and yellow may appear in the
soapstone. This is a natural reaction in the
soapstone. Surface or hairline fractures may also
appear in the stone after a stove is used. Such
changes are normal and do not affect the operation
or the integrity of the stove and do not require
replacement. If you observe a completely broken
stone, contact your dealer for service.
C P
ERAMIC ANELS
The ceramic panels do not require maintenance other
than an occasional dusting. On a cold stove use a dry,
clean cloth to wipe off any debris that may have
landed on the panels or top ring. A standard glass
cleaner may be used lightly to remove any stains
40
( )
IF EQUIPPED
Bari Model 8171