HearthStone Bari 8171 Installation And Operating Instructions Manual page 32

ASH PAN: (This becomes hot during operation. It is
best to remove the ash pan only after the stove
cools). To access the ash pan you must open the
control door, which is located under the firebox door.
Open the control door and locate the ash pan's
handle. The lid for the ash pan is stored under the
ash pan. Use the lid to contain the ashes during
transport for disposal. The lid must be stored in
place under the ash pan to support it, or the pan
will not seal properly. The ash pan collects the ash
residue from each fire and when full, allows you to
remove the ash conveniently from your wood stove.
Clear the firebox of ashes periodically by opening the
ash grate in the bottom of the firebox. Sift the ashes
through the grate into the ash pan, and then return
the grate to its closed position.
To replace the ash pan, place the pan lid back into
the bottom of the ash pan receptacle and slide the
ash pan back into place on top of the lid. The lid must
be upright to support the ash pan properly.
•
Do not operate the stove unless the ASH PAN
is in place, and properly sealed. Not doing
this could overheat and damage the stove.
PRIMARY AIR CONTROL: The primary air control
handle (B) is located on the front lower right of the
stove, just under the ash pan. The primary air control
allows you to regulate the amount of air entering the
firebox. Generally, the more air allowed into the
firebox, the faster the rate of burn; conversely, less
air creates a slower burn. For maximum air flow, pull
the primary air handle as far out as possible; push
Hearthstone Quality Home Heating Products, Inc ®
the primary air control handle in as far as possible for
minimum air flow (does not close completely).
•
CAUTION: THE
SHOOULD NEVER BE ALTERED FROM FACTORY
CONFIGURATION TO INCREASE FIRING.
ROTATION CONTROL: Your Bari rotates a full 180
degrees. With the stove centered on your hearth, it
will rotate 90 degrees to the left and 90 degrees to
the right. There are 13 possible positions.
To access the rotation control you must open the
control door that is located under the firebox door.
Open the control door and locate the push button (A)
Push the button to free the unit to rotate to the
position you desire. Once the stove is in position,
push the button again and slightly turn the stove to
ensure it locks into position. If the stove is positioned
as you like, close the control door and enjoy the fire.
BYPASS HANDLE: The bypass handle controls
the bypass door inside the stove. When the handle
is in-line with the flue the bypass is open, and when
the handle is horizontal, the bypass door is closed.
The bypass door directs the flow of combustion
products through or around the catalytic combustor.
32
AIR CONTROL
B
Bari Model 8171
SYSTEM