Glass - HearthStone Bari 8171 Installation And Operating Instructions Manual

G
LASS
Do not operate the stove with a broken door glass. Do
not abuse the front door by striking or slamming.
When necessary, clean the glass with commercial
stove glass cleaners, which are available from your
local dealer. Never attempt to clean the glass while
the fire is burning or while the glass is hot. Remove
deposits by following the instructions provided with
the cleaner. To clean heavier, stubborn deposits,
remove the door from the stove (See door removal
procedures on page 37). Lay the door face down on
a clean, padded workbench or table, use rolled up old
towels, or similar, to stabilize the curved door so the
heavy deposits are at the lowest point. Apply the
cleaner to the glass and allow it to soak for a few
minutes. Reposition the door as necessary to allow
the cleaner to penetrate all the heavy deposits. Wipe
the cleaner off with a soft cloth, or black & white
newsprint.
Important: scratching or etching the glass will
weaken the integrity of the glass. Do not use a
razor blade, steel wool, or any other abrasive
material to clean the glass. Use a cleaner
specifically manufactured for woodstoves only.
The front door glass is a ceramic, shock-resistant
glass, made specifically for use in woodstoves. Do
not use any replacement glass other than the ceramic
glass manufactured and supplied for use in this
woodstove. Replacement glass is available through
your local Hearthstone dealer.
Replace the door glass immediately if broken or
chipped. Contact your local dealer for replacement
glass. The glass kit includes instructions and
everything needed for the repair. If you replace the
glass yourself, wear work gloves and safety glasses.
Required Glass Kit: Part Number: 040-057-V
(Glass with gasket applied).
G
LASS REPLACEMENT PROCEDURES
1. Follow the instructions
replacement glass kit.
2. Remove the door (see door removal procedure
on page 37).
3. Remove the screws from the glass retainer (use
penetrating oil if necessary) – lift the retainer off
the glass. Set aside for reinstallation.
4. Remove the inner glass frame from around the
glass. Set aside for reinstallation.
5. Carefully lift the damaged glass out of the door
and discard.
Hearthstone Quality Home Heating Products, Inc ®
:
included with the
39
6. Remove any remaining glass and old gasket
material.
7. Clean the screw holes and place a small amount
of anti-seize compound in each one.
8. Place the gasketed new glass onto the door.
9. Important! Center the glass and ensure that the
edges of the curved glass are parallel with the
edges of the opening.
10. Reinstall the inner glass frame (limits pressure on
glass from the retainer).
11. Check glass position again (centered, and
parallel), then screw the glass retainer back on
the door using a crisscross pattern. Tighten the
screws no more than 1/8
seat. (The glass will break at this point if not
positioned correctly. If the glass shifts too much
to one side, you will see the gasket from the
outside)
12. Apply a light film of anti-seize lubricant on the
door's hinge pins and washer if needed.
13. Install the door.
14. After 5 or 6 fires, check the glass retainer screws,
and retighten if necessary.
Figure 7: Glass Assembly
Bari Model 8171
th
of a turn after they