Engine - Toro Sand Pro 3040 Service Manual

Engine

g341964
1. Spacer (2 used)
2. Exhaust shield
3. Wire harness connections
4. Starter motor power cable
5. Cap screw (4 used)
6. Cap screw (8 used)
7. Lock nut (4 used)
8. Washer (4 used)
9. Engine mount (4 used)
Removing the Engine
Sand Pro ® 3040 and 5040
20251SL Rev A
10. Lock nut (8 used)
11. Engine Support
12. Lock nut (4 used)
13. Lock washer
14. Ground cable
15. Cap screw (4 used)
16. Cover
17. Muffler
18. Cap screw (4 used)
Refer to Figure 15 for this procedure.
1. Park the machine on a level surface, lower any attachments, apply the
parking brake, set the key switch to the Off position and remove the key
from the switch.
2. Remove any rear attachments from the machine.
3. Remove the battery from the machine; refer to
Battery (page 6–31).
Figure 15
19.
20.
21.
22.
23.
24.
25.
26.
Page 4–15
Exhaust gasket (2 used)
Engine assembly
Cap screw (2 used)
Muffler guard
Breather tube
Gasket
Intake elbow
Cap screw (4 used)
Removing and Installing the
Engine: Service and Repairs