Toro Sand Pro 3040 Service Manual page 188

Installing the Hydraulic Switch Kit Manifold
Hydraulic System: Service and Repairs
Refer to Figure 74 for this procedure.
1. If the hydraulic fittings were removed from the manifold, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
g352717
1. Cap – male coupler (2 each)
2. Cap – female coupler
3. Coupler – female
4. Adapter (3 each)
5. Elbow fitting (3 each)
2. Ensure that all manifold components are properly installed prior to installing
the manifold into the machine; refer to
Switch Kit Manifold (page
3. Secure the manifold assembly and the coupler panel to the hitch tube with
the previously removed fasteners.
4. Position the previously removed fastener through the R-clamp, manifold
bracket, and frame tube.
Note: Install the hydraulic tank clamp and locknut when installing the
hydraulic tank later in this procedure.
5. Remove the caps and plugs then connect the hydraulic tubes and hoses to
the manifold fittings; refer to
Face Seal Fitting) (page
6. Connect the wire harness connectors to the solenoid valves.
7. Install the hydraulic tank; refer to
Installing the Hydraulic Fittings
Figure 75
6. Manifold assembly
7. Straight fitting (2 each)
8. Elbow fitting
9. Coupler – male (2 each)
Servicing the Optional Hydraulic
5–119).
Installing Hydraulic Hoses and Tubes (O-Ring
5–7).
Installing the Hydraulic Tank (page
Page 5–118
5–9).
Sand Pro ® 3040 and 5040
20251SL Rev A
5–67).