Front Lift Cylinder (Optional) - Toro Sand Pro 3040 Service Manual

Front Lift Cylinder (Optional)

Removing and Installing the Optional Front Lift Cylinder
Sand Pro ® 3040 and 5040
20251SL Rev A
g351815
1. Retaining ring
2. Lift cylinder
3. Retaining ring (2 each)
4. Cylinder pin
Refer to Figure 69 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
3. Clean the fitting and hydraulic hose connections before disconnecting the
hydraulic hoses to prevent system contamination.
4. Disconnect the hydraulic hoses. Cap the fittings and plug the hoses to
prevent system contamination.
5. Remove the retaining rings that secure the cylinder to the machine, then
remove the cylinder and cylinder pin from the machine.
6. If the hydraulic fittings are to be removed from the cylinder, mark the fitting
orientation for assembly purposes and remove the fittings from the cylinder.
Discard the O-rings from the fittings.
7. Install the optional front lift cylinder in the reverse order.
8. If the hydraulic fittings were removed from the cylinder, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
Figure 69
5. Elbow fitting
6. Elbow fitting
7. Hydraulic hose assemblies
FF
Installing the Hydraulic Fittings
Page 5–107
position and remove the key
General Precautions for
5–54).
5–9).
Hydraulic System: Service and Repairs