Rear Lift Cylinder - Toro Sand Pro 3040 Service Manual

Rear Lift Cylinder

Removing the Rear Lift Cylinder
Hydraulic System: Service and Repairs
g351871
1. Cap screw
2. Pin
3. Lift cylinder
Refer to Figure 62 for this procedure. The rear lift cylinder is located on the
left side of the machine.
1. Park the machine on a level surface, lower any attachments, set the key
switch to the O position and remove the key from the switch.
FF
2. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
3. Clean the fitting and hydraulic hose connections before disconnecting the
hydraulic hoses to prevent system contamination.
4. Disconnect the hydraulic hoses. Cap the fittings and plug the hoses to
prevent system contamination.
5. Remove the fastener from the pin that secures the cylinder clevis to the rear
hitch and slide the pin from the hitch and the lift cylinder.
6. Remove the fasteners that secure the lift cylinder to the frame and remove
the lift cylinder from the machine.
7. If the hydraulic fittings are to be removed from the cylinder, mark the fitting
orientation for assembly purposes and remove the fittings from the cylinder.
Discard the O-rings from the fittings.
Figure 62
(view from under machine)
4. Rear hitch
5. Cap screw
6. Flat washer
Page 5–94
General Precautions for
5–54).
Sand Pro ® 3040 and 5040
20251SL Rev A