Adjusting The Traction System For Neutral - Toro Sand Pro 3040 Service Manual

Adjusting the Traction System for Neutral

Hydraulic System: Adjustments
The traction pedal must return to the N
the forward or reverse position. The machine must not creep in either direction
on level ground when in the traction pedal is in the N
traction system for neutral as follows:
1. Park the machine on a level surface, lower any attachments and set the key
switch to the O position.
FF
2. Remove the center shroud.
Review and follow the
the machine.
3. Raise all of the wheels off the ground and support the machine with jack
stands.
4. Loosen the lock nut on the traction (piston) pump adjustment cam.
g350623
1. Lock nut
2. Traction adjustment cam
5. Have an assistant sit in the Operator's seat, start the engine, and set the
throttle to high idle.
6. Use the large hex on the adjust the cam to adjust the N
A. Turn the adjustment cam slowly until the wheel begins to rotate in the
forward direction (position F).
position when released from either
EUTRAL
WARNING
Jacking Instructions (page 1–6)
Figure 46
3. Traction neutral switch
Page 5–52
position. Adjust the
EUTRAL
before lifting
position:
EUTRAL
Sand Pro ® 3040 and 5040
20251SL Rev A