Towing The Traction Unit - Toro Sand Pro 3040 Service Manual

Towing the Traction Unit

Hydraulic System: General Information
If towing limits are exceeded, severe damage to the hydraulic pump
may occur.
If it becomes necessary to tow or push the machine, the traction pump must be
set to bypass hydraulic fluid. Move the machine at a speed below 4.8 kph (3
mph), and for a very short distance. If the machine needs to be moved more
than a short distance, the machine should be transported on a trailer.
1. The traction pump bypass valve is located on the left side of the traction
pump. Access the bypass valve from under the machine.
g342233
1. Bypass valve
2. Hydraulic filter
2. Use an 17 mm wrench to loosen the bypass valve, then open the valve 3
revolutions maximum.
Do not start or run the engine when the valve is set to the bypass
position.
3. After towing and before starting the engine, tighten the bypass valve to 12
N·m (9 ft-lb).
IMPORTANT
Figure 18
3. Traction pump
IMPORTANT
Page 5–4 Sand Pro ® 3040 and 5040
20251SL Rev A