Toro Sand Pro 3040 Installation Instructions
Finish grader kit
Hide thumbs
Also See for Sand Pro 3040:
- Service manual (262 pages) ,
- Operator's manual (44 pages) ,
- Manual (12 pages)
Advertisement
Quick Links
Finish Grader Kit
Sand Pro
Model No. 08754–Serial No. 260000001 and Up
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
106-5517
1. Warning—do not touch the hot surface.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
Description
Finish Grader Assembly
Parts Catalog
Installation Instructions
Installation
Mount the Finish Grader to the Traction
Unit
1. Remove any attachment from the rear of the machine.
2. Back the traction unit into position in front of the
attachment adapter. Lower the traction unit adapter.
Note: Make sure the locking lever (Fig. 1) is pivoted to
the left (unlocked position) as viewed from the rear of the
machine.
3. Raise the traction unit adapter into the attachment
adapter.
4. Pivot the locking lever to the right to lock the adapters
together.
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
)
3040 & 5040
Qty.
1
1
1
Rear of machine
1. Attachment adapter
1
Form No. 3354–263 Rev. A
Installation Instructions
Use
Mount to the Sand Pro lift arm adapter
1
Figure 1
2. Locking lever
2
All Rights Reserved
Printed in the USA
Advertisement
Related Manuals for Toro Sand Pro 3040
Summary of Contents for Toro Sand Pro 3040
-
Page 1: Loose Parts
Figure 1 4. Pivot the locking lever to the right to lock the adapters together. 1. Attachment adapter 2. Locking lever W 2006 by The Toro Company 8111 Lyndale Avenue South All Rights Reserved Bloomington, MN 55420-1196 Printed in the USA... - Page 2 Adjusting the Link Assembly 1. With the attachment mounted and secured on the traction unit, raise the attachment. 2. Measure the gap between the top washer and the spacer in the link assembly on the attachment adapter as shown in figure 2. The gap between the washer and the shoulder should be 0.060 to 0.080 inch Figure 3...
- Page 3 Maintenance Leveling the Finish Grader Blade To level the blade in relation to the traction unit, place the unit on a level surface (such as a concrete driveway), and Greasing the Attachment slightly vary the rear tire pressure as required. If the locking lever on the attachment adapter does not pivot freely and easily, apply a light coat of grease to the Reversing the Scraper Blade...
- Page 4 If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.