Starting The Engine; Driving The Machine; Stopping The Machine; Shutting Off The Engine - Toro Workman 07390H Operator's Manual

Hdx-auto utility vehicl
Hide thumbs Also See for Workman 07390H:
Table of Contents

Advertisement

1. Latch handle
2. Latch gate

Starting the Engine

Important:
Do not attempt to push or tow the
machine to get it started. Damage to the drive
train could result.
1.
Sit on the operator seat and engage the parking
brake.
2.
Disengage the PTO and the high-flow hydraulics
(if equipped) and move the hand-throttle lever to
the O
position (if equipped).
FF
3.
Move the transmission lever to the P (P
position.
4.
Ensure that the hydraulic-lift lever is in the O
position (center).
5.
Press the brake pedal.
Note:
Keep your foot off the accelerator pedal.
6.
Insert the key into the key switch and rotate it
clockwise to start the engine.
Note:
Release the key switch when the engine
starts.
Note:
The oil-pressure warning light should
turn off.
Important:
To prevent overheating of the
starter motor, do not engage starter longer
Figure 22
3. Latch pin
than 15 seconds. After 15 seconds of
continuous cranking, wait 60 seconds before
engaging starter motor again.

Driving the Machine

1.
Press the brake pedal.
2.
Disengage the parking brake.
3.
Move the transmission lever to the desired gear.
4.
Release the service brake and gradually press
in the accelerator pedal.
Important:
shifting to reverse a forward gear or to a
forward gear from reverse.
Use the chart below to determine the ground
speed of each gear when operating the
machine with the speed-range control in the T
(T
RANSPORT
Gear
g026141
R (R
EVERSE
L (L
F
OW
ORWARD
D (D
)
RIVE
Note:
of time.
Note:
for long periods of time without starting the
engine discharges the battery.

Stopping the Machine

To stop the machine, remove your foot from the
accelerator pedal, then press the brake pedal.
)
ARK

Shutting Off the Engine

1.
Stop the machine.
FF
2.
Move the transmission lever to the P (P
position.
3.
Engage the parking brake.
4.
Rotate the key switch to the O
remove the key.
25
Always stop the machine before
) position.
Speed (km/h)
)
0 to 21
)
0 to 18
0 to 32
Avoid idling the engine for long periods
Leaving the key switch in the O
Speed (mph)
0 to 13
0 to 11
0 to 20
position
N
)
ARK
position and
FF

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workman 07390Workman 07390tc

Table of Contents