Operator's Console - Toro Sand Pro 3040 Service Manual

Operator's Console

Removing and Installing the Operator's Console
Chassis: Service and Repairs
g351974
1. Operator's console
2. Flat washer (7 each)
3. Cap screw (7 each)
4. Lock washer (3 each)
5. Flat washer (4 each)
6. Cap screw (4 each)
Refer to Figure 101 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the knob(s) from the lift control valve lever(s).
3. Remove the fasteners securing the dash panel to the console. Raise the dash
panel and disconnect the wire harness from the hour meter and the optional
PTO switch, then remove the dash panel assembly from the machine.
4. Press the tang of the carbon canister bracket upward and slide the carbon
canister forward and out of the bracket.
5. Remove the 3 cap screws, lock washers and flat washers that secure the
console to the frame and remove the operator's console from the machine.
Note: The console support plate is fastened to the console.
6. Install the operator's console in the reverse order.
Figure 101
7. Knob
8. Dash panel assembly
9. Carbon canister
10. Lock nut (4 each)
11. Console support plate
12. Carbon canister bracket
FF
Page 7–24
position and remove the key
Sand Pro ® 3040 and 5040
20251SL Rev A