Hydraulic Fluid Cooler - Toro Sand Pro 3040 Service Manual

Hydraulic Fluid Cooler

g349636
1. Center Shroud
2. Dash Shroud
3. Rear fuel tank clamp (2 each)
4. Dash Panel
Removing and Installing the Hydraulic Fluid Cooler
Hydraulic System: Service and Repairs
5. Elbow fitting
6. Elbow fitting (model 08743)
7. Tee fitting (model 08745)
8. Hydraulic fluid cooler
Refer to Figure 50 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the center shroud (above) and the cooler panel (below) from the
machine.
3. Remove the 3 screws that secure the dash panel to the machine, then
carefully raise the dash panel to access the rear fuel tank clamps. Remove
the rear fuel tank clamps.
Figure 50
10.
11.
FF
Page 5–68
9. Rubber clamp (2 each)
Fan shroud
Cooler panel
position and remove the key
Sand Pro ®
20251SL Rev A
3040 and 5040