Grease And Lubrication Schedule; Hydraulic Fluid System - Toro MH-400 Operator's Manual

Grease and Lubrication Schedule

Figure 33 shows the grease point locations.
•
Use an automotive all-purpose grease.
•
A spray or brush-on lubricant may be used on the
conveyer drive chain instead of grease.
•
Lubricate regularly, after 25 hours of normal
operation.
•
Lubricate daily when operating in extremely dusty
and dirty conditions.
Grease Lubrication Schedule
Wheel bearings
Suspension bearings
Front take-up bearings
Rear drive bearings
Box hinge pins
Floor drive chain
: Do not over-grease, or the bearing seals
I
MPORTANT
may be damaged. Two or three squirts per grease
point is usually enough, except when repacking the
wheel bearings.
: Replace all guards after
W
ARNING
servicing.
Page 42
Figure 33: Grease points
Clean and repack every year
or 300 hours
Once per year
Every 2 months or 25 hours
Every 2 months or 25 hours
Every 2 months or 25 hours
Every 2 months or 25 hours
•
Clean grease fitting of foreign matter.
•
Pump grease into all bearings and bushings.
•
Clean off excess grease.
•
Clean and repack wheel bearings every year or 300
hours.
: Do not over-grease, or the bearing seals
I
MPORTANT
may be damaged. Two or three squirts per grease
point are usually enough, except when repacking the
wheel bearings.

Hydraulic Fluid System

The machines reservoir is filled with approximately 19
U.S. gallons (71.9l) of high quality hydraulic fluid. Check
the level of the hydraulic fluid before the engine is first
started and daily thereafter. The recommended
replacement fluid is: Toro Premium All Season Hydraulic
Fluid (Available in 5 gallon pails or 55 gallon drums. See
Parts Catalog or Toro distributor for part numbers.)
Alternate fluids: If the Toro fluid is not available, other
fluids may be used provided they meet all the following
material properties and industry specifications. We do not
recommend the use of synthetic fluid. Consult with your
lubricant distributor to identify a satisfactory product.
Note: Toro will not assume responsibility for damage
caused by improper substitutions, so use only products
from reputable manufacturers who will stand behind their
recommendation. High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG46.
Maintenance Instructions