Adjusting The Neutral Gear-Shift Position; Maintaining The Primary-Drive Clutch - Toro Workman 07040 Operator's Manual

Adjusting the Neutral
Gear-Shift Position
1. Loosen the jam nuts on the gear-shift cable and
adjust them as necessary
Figure 58
1. Shift lever
2. Spanner bar
2. Test the gear-shift position by rotating the
gear-shift selector to the 3 different positions
and check to see if the shift lever
shifts properly when shifting the gears; refer to
Gear-Shift Lever and Gear-Shift Indicator (page
13).
3. Verify that all of the positions are working
correctly by repeating the steps in
Neutral Gear-Shift Position (page
(Figure 58).
g034455
3. Gear-shift cable
4. Jam nuts
(Figure 58)
Checking the
47).
Maintaining the
Primary-Drive Clutch
Service Interval: Every 400 hours/Yearly (whichever
comes first)
CAUTION
The dust in the clutch becomes airborne and
could damage your eyes, or you could inhale
it, causing breathing difficulties.
Wear eye and respiratory protection when
performing this procedure.
1. Raise and latch the cargo bed; refer to
the Cargo Bed to the Dump Position (page
2. Remove the 3 bolts securing the cover to the
clutch, and remove the cover
Note:
Retain the cover and bolts for installation.
1. Cover
3. Thoroughly clean the inside of the cover and
the inner components of the clutch using
compressed air.
4. Install the clutch cover and secure it with the 3
bolts (Figure 59) that you removed in 2.
5. Lower the cargo bed.
48
(Figure 59).
Figure 59
2. Bolts
Raising
20).
g011947