Explanation Of Footnotes - Fronius Primo GEN24 3.0 Plus Operating Instructions Manual

Fronius Primo GEN24
Voltage level of digital inputs
Input currents of digital inputs
Total power for digital output
(internal supply)
Power per digital output
(external supply)
Datalogger/web server
Explanation of
1)
footnotes
2)
3)
4)
5)
6)
7)
142
The values stated are defaults; the inverter is configured specifically to suit the
requirements of the relevant country.
Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive).
Maximum current from a defective solar module to all other solar modules.
Guaranteed by the electrical configuration of the inverter.
For backup power mode (PV Point) without battery, a minimum voltage of 150 V
is required.
Current peak when switching on the inverter.
The sum of the nominal output power per phase must not exceed the nominal
output power of the inverter.
4.6 / 4.6 Plus 5.0 / 5.0 Plus
low: min. 0 V–max. 1.8 V
high: min. 4.5 V–max. 28.8 V
depending on the input voltage;
input resistance = 70 kOhm
6 W at 12 V (USB not connected)
1 A at >12.5 V-24 V
(max. 3 A in total)
Integrated
6.0 / 6.0 Plus