Fronius Primo GEN24 3.0 Plus Operating Instructions Manual page 65

7
8
9
Use a suitable measuring instrument to
check the voltage and polarity of the DC
cabling. Remove both DC terminals from
the slots.
CAUTION!
Danger due to polarity reversal at the
terminals.
This may result in severe damage to the
inverter.
▶
Use a suitable measuring instrument
to check the polarity of the DC
cabling.
▶
Use a suitable measuring instrument
to check the voltage (max. 600 V
Insert the DC terminals into the respective
slot until they engage. Fasten the screws
of the cable guide to the housing using a
screwdriver (TX20) and a torque of
1.3-1.5 Nm.
NOTE!
Do not use a drill driver as this could
cause overturning.
A possible consequence of overturning is,
for example, damaging the strain-relief
device.
)
DC
65