Fronius Primo GEN24 3.0 Plus Operating Instructions Manual page 69

7
8
IMPORTANT!
Information for connection on the battery side can be found in the Installation Instructions
from the relevant manufacturer.
Insert the DC terminals into the respective
slot until they engage.
Fasten the screws of the cable guide to
the housing using a screwdriver (TX20)
and a torque of 1.3-1.5 Nm.
NOTE!
Do not use a drill driver as this could
cause overturning.
A possible consequence of overturning is,
for example, damaging the strain-relief
device.
69