Setting Functions With The Control Panel; Quick User Guide (068-13884) See Fold-Out Page - Sensopart FT 50 RLA 70-L8 Mounting And Operating Instructions

Keys In operating mode
SET
No function
SET
Activate factory setting during
Power ON:
Keep
until the LEDs stop flashing and light up
permanently. The operating indicator BA
lights up green.
Once the
sensor is reset. The FT 50 RLA is now in
its initial state.
No function
Continue
Unlock keys during Power ON:
Keep
until the LEDs stop flashing and light up
permanently. The status indicator ZA
lights up red.
The control panel is unlocked once the
INFORMATION
A time lock prevents short unintentional pressure on the keys from activating configuration
mode.
7.2

Setting functions with the control panel

7.2.1

Quick user guide (068-13884) see fold-out page

50
SET
key pressed (approx. 10 s),
SET
key is released, the
key pressed (approx. 10 s),
key is released.
General operating functions
In configuration mode
A brief pressing of the
status of respective function or activates storage
and confirmation of the set values.
The function status is indicated by the status
indicator ZA
(LED ON = active, LED OFF = not active).
Press the
the function table.
The function number is indicated by a clear LED
pattern.
The first function follows the last available
function.
FT 50 RLA Disctance sensor - GB - 068-13671 - 20.04.2009-05
Mounting and
operating instructions
SET
key changes the
key to select the next function in