Displays And Configuration Elements - Sensopart FT 50 RLA 70-L8 Mounting And Operating Instructions

Mounting and
operating instructions
7.1

Displays and configuration elements

The LEDs (illustr. 11) indicate the selected menus and configurations.
BA ZA
Q Q
1 2
I OK
C FA
SET
Illustr. 11
15500272
Keys and their functions:
The FT 50 RLA is configured using the
Keys In operating mode
Activate set-up mode:
Simultaneously pressing these keys
(> 3 s) activates the set-up mode.
After this period, the power supply
indicator BA flashes
Entire control
 set FT 50 RLA, see illustr. 11.
panel
The LEDs show the status of function
no.1.
SET
When all the LEDs start immediately
flashing
 Unlock FT 50 RLA, see
„Unlocking keys" (below).
FT 50 RLA Disctance sensor - GB - 068-13671 - 20.04.2009-05
LED Colour In operating mode
BA Green Operating indicator (LED lights up,
when sensor is ready for use)
ZA Red
Q Yellow Lights up when Q
1
is active
Q Yellow Lights up when Q
2
I Green Lights up when Q
Q enable input function is active
1
OK Green Good Target (lights up when object
is detected and in measuring
range)
C Green Lights up when sensor is program-
med as master or slave
FA Green Lights up when Q
or Q autom. zero function is
1
active
SET and
input/output
1
output is active
2
trigger input or
1
autom. centre
1
keys.
General operating functions
In configuration mode
Quit set-up mode:
First press the
key.
All settings are then stored.
SET
Once the
RUN mode.
The operating indicator BA lights up permanently
again.
INFORMATION
Should the power supply fail during the
setting procedure, all settings are lost.
In configuration mode
LED flashes, when set-up mode
is active.
Staus indicator:
Lights up when function is active.
Off, when function is not active.
During teach-in: confirmation
signal
Table of functions on chapter 7.2.2
onwards explains the significance
of the Q , Q , I, OK, C and FA
1 2
LEDs in set-up mode.
key and then also the
key is released, the sensor is in
SET
49