Setting Triggers For Exceedances Or Events - Larson Davis SoundAdvisor Reference Manual

SoundAdvisor Model 831C
•
If you press Run at 10:10, the measurement record will store at 11:05,
12:05, and so forth. In this case, the initial measurement record will
contain only 50 minutes, while all others will contain the full hour.
Step 2 If desired, enable any additional settings on the Control tab, and move to
section 6.2.4 Setting Triggers for Exceedances or
Using Single Block Timer Mode
Recommended for:
Strength:
Step 1 Select Single Block Timer from the Run Mode drop-down menu.
a. Enter a Start (y-m-d) date and Time, and an End (y-m-d) date
and Time, where Time is the time of day.
Step 2 If desired, enable any additional settings on the Control tab, and move to
6.2.4 Setting Triggers for Exceedances or
Using Daily Timer Mode
Recommended for:
Strength:
Use Daily Timer mode to schedule one or more measurements, which
start and stop according to the time you set, every day until the End
date.
Step 1 Select Daily Timer Mode from the Run Mode drop-down menu.
a. Enter a Start (y-m-d) date and Time, and an End (y-m-d) date
and Time, where Time is the time of day.
b. If desired, select the checkbox in-line with 2, and 3 to enter
additional measurement periods.
Creating a Custom Setup File
Time (hh:mm:ss): 00:10:05
unmonitored measurements
One measurement automatically starts and
stops at the date and time you set.
Work area surveys which follow a worker's daily
schedule and account for breaks.
Totally autonomous, daily intermittent
measurement for long or short number of days.
Events.
Events.
6-10