Du Pont Cyrel FAST 2000TD Operation Manual page 88

A-2
Alarm No
002 004 Plate detached from clamp arms
002 005 Clamp Arms, front, speed to low in
tension mode
002 006 Process stopped before plate was
loaded or ejected completely
002 007 Process stopped while plate was
being processed
002 008 Plate too short, please unload
002 020 Front Clamp Arm, drive error
002 021 Motor could not move as expected.
002 022
002 023
Drive power failure.
002 024
002 025 Front Clamp Arm, drive error-39022
Battery low warning.
002 030 Rear Clamp Arm, drive error
002 031 Motor could not move as expected.
002 032
002 033
Drive power failure.
002 034
002 035 SFA change mode\nMachine can't be
started
002 036 Rear Clamp Arm, drive error -39022
Battery low warning.
003 020 Heated Roller, drive error
003 021 Motor could not move as expected.
003 022
003 023
Drive power failure.
003 024
003 025 Heated Roller, TCO Tripped
003 026 IR, Thermal Cut Out (TCO) tripped
Operation Manual|Cyrel FAST 2000TD
Description Remedy
Plate loss, please check.
Process was stopped by operator during load or
eject.
Process was stopped by operator.
The loaded plate is shorter than the specified
minimum lenght (450 mm). Please eject.
Check for jammed plates and mechanical failures
before initializing.
If the problem persists, please call an authorized
Service Technician.
Check the safety circuit and the machine power
supply before initializing.
If the problem persists, please call an authorized
Service Technician.
Please call an authorized Service Technician.
Check for jammed plates and mechanical failures
before initializing.
If the problem persists, please call an authorized
Service Technician.
Check the safety circuit and the machine power
supply before initializing.
If the problem persists, please call an authorized
Service Technician.
After finished SFA change, Initialize machine to
proceed.
Please call an authorized Service Technician.
Check for jammed plates and mechanical failures
before initializing.
If the problem persists, please call an authorized
Service Technician.
Check the safety circuit and the machine power
supply before initializing.
If the problem persists, please call an authorized
Service Technician.
Please call an authorized Service Technician.
Please call an authorized Service Technician.
Appendix A
January, 2020