Du Pont Cyrel FAST 2000TD Operation Manual page 63

Maintenance
9. Press the 'Enable maintenance mode' button.
10. Wait till maintenance mode is enabled: the
'STATE IDLE' changes to 'STATE
STOPPED' and at the same time the LED will
to turn green.
11. Press the 'Arms to Service Pos.' button.
12. Press the SFA Change move arms to safe
pos. This will automatically rotate both sets of
clamp arms to the low position in the machine.
Once in position the lamp will turn green.
13. Once the arms are in the safe position, the
black plastic stripping finger plate will be
activated in the down position to help access
to the rubber roller.
WARNING: It is not possible to operate the
machine in this condition.
14. Lift the top cover and start to clean both the
hold down roller and rubber roller.
January, 2020 Operation Manual|Cyrel FAST 2000TD
4-5