Table of Contents
Advertisement
3.3 DVB-C installation
Cable Setting
Press pq t u to highlight your settings.
Scan type
Network ID
Frequency
Symbol
Optional you can search also for analogue channels.
Press p select the Tune Type.
By pressing t u select DTV, ATV or DTV+ATV (DTV to search digital broadcasts and ATV to search
analogue broadcasts).
NOTE:
Press ENTER to start searching for digital channels.
4.0 ELECTRONIC PROGRAMME GUIDE (EPG)
EPG stands for Digital Electronic Programme Guide. It is supplied by the programme providers and offers
information on broadcasted programmes. You can access it in digital mode by pressing EPG on the
remote control. Press EPG to bring up the EPG interface. Use pq to select a channel.
Press u to switch to overview from one channel EPG. Use DOWN/UP to select event where you like to
know more details. These details are displayed on top of this EPG banner or press INFO button for full
screen. Press EXIT to stop and return to viewing modes.
Then press the COLOUR BUTTONS for entering the required settings.
GREEN
Set a reminded to event or set even Timer function.
YELLOW
Overview of previous day
BLUE
Overview of next day
5.0 MENU SETTINGS
Below items depend if they are available of select input source. Use SOURCE to select other source.
Selections are Satellite, DTV, ATV, AV, PC, SCART, Component, HDMI and Media.
5.1 Menu control (DTV mode)
Press MENU to enter the main menu. Press t u to select an item. Press pq and ENTER to select the
submenus. Press MENU to exit the item.
8
You can select Network Scan, Blind scan or Full.
Please enter (with 0 ~ 9) the used Network ID from your provider.
Please enter (with 0 ~ 9) the main frequency used by your provider in KHz.
Please enter (with 0 ~ 9) the used Symbol from your provider. (Ks/s) most used
values are 6900 or 6875.
Please check the settings for your cable system used by your provider! Full
scan will have a duration of approximately 20 minutes, depending on your
cable network.
Advertisement
Table of Contents
