Power Meter Configuration - ViM JBRB ECOWATT PR Instruction Manual

6.14 Power meter configuration

After connecting the power meter to the power supply (see § "5.10 Electrical connection of a CENE pow-
er meter (optional accessory)", page 24), configure as follows:
Settings possible at installer level only (§ "6.3 Access levels", page 25).
6.14.1 Configuration of power meter DI4 input
SYSTEM
CONFIGURATION
4 - ON-OFF AND
DIGIT. INPUT CONFIG
6.14.2 Set number of impulses per kWh transmitted by the meter used.
SYSTEM
CONFIGURATION
4 - ON-OFF AND
DIGIT. INPUT CONFIG
6.14.3 Meter reading
SYSTEM
CONFIGURATION
INPUT/OUTPUT
STATUS
5 x
P426 DI4DIGIT INPUTS
CONFIG
QUICK INPUT:
WITHOUT
QUICK INPUT: POWER
METER
5 x
P430 POWER METER
FACTOR
METER FACTOR:
100 imp/kWh
METER FACTOR:
220* imp/kWh
ANALOGUE
INPUT 1 0.0V
POWER METER:
18kWh*
39/48
Set on POWER METER.
Set the number of impulses
transmitted by the meter
*Example
5 x
Read the power meter value recorded by the
RMEC*Example
NT00000603-JBRB-ECOWATT-PR-AN-191202