Checking The O-Ring - Fantasea Line FA6400 Instruction Manual

Image #19
3. Carefully open the back side of the housing.
CHECKING THE O‐RING
1. Prior to each closure of the housing, the back door black O‐ring should be visually inspected. If there
is any debris present, including dirt, sand, dust, hair or any other matter, it must be cleaned to
ensure a proper watertight seal.
2. In order to clean the black O‐ring, first remove it from the housing:
a. Insert the O‐ring remover between the black O‐ring and the groove it is
seated in (image #21).
b. Slip the tip of the inserted
O‐ring remover below the
black O‐ring, while making
sure the O‐ring doesn't get
damaged (image #22).
c. Carefully hold the O‐ring
with your fingertips in order
to remove it from the
groove.
Image #20
Image #21
24
Image #22
FA6400 Housing Instruction Manual 20190416