Table of Contents
Advertisement
Connectors are provided on the connector end cap of the Sonar Electronics and the
Sonar Processor as shown in Figure 3-2 and Figure 3-3.
The connections on the Sonar Electronics connector end cap are the following:
RX-PORT:
TX-PORT:
RX-STBD:
TX-STBD:
T/C:
ALT:
The connections on the Sonar Processor connector end cap are the following:
Sonar Electronics Interface:
AUV Host and Deck Cable
Interconnect:
Test Cable Interconnect:
Each of the two transducer arrays includes two interconnect cables, one that
connects to a receiver (RX-PORT or RX-STBD) of the Sonar Electronics, and the
other that connects to the corresponding transmitter (TX-PORT or TX-STBD) of
the Sonar Electronics. These interconnect cables are shown in Figure 3-4.
Connecting the System Components
Connects to the port side transducer
array receiver interconnect cable.
Connects to the port side transducer
array transmitter interconnect cable.
Connects to the starboard side transducer
array receiver interconnect cable.
Connects to the starboard side transducer
array transmitter interconnect cable.
Connects to the Sonar Processor using
the jumper cable.
Connects to an optional altimeter
transducer.
Connects to the Sonar Electronics using
the jumper cable.
Connects directly to the AUV host using
a user supplied cable, or to a deck cable
which connects to the AUV host when it
is at the surface. The deck cable has
individual breakout connections for
power and communications.
Used for factory test and service. A
dummy plug is provided which mates
with this connector during normal
operations. The dummy plug should
remain installed at all times.
3-3
Advertisement
Table of Contents
