Table of Contents
Advertisement
Figure 3-4:
To connect the Series 5000 AUV V2 Sonar System components:
Verify that the connector internal O-ring seals are in place, and then connect
1.
the TRANSMITTER interconnect cable of the port transducer array to the
TX-PORT connector on the Sonar Electronics; connect the RECEIVER
interconnect cable to the RX-PORT connector.
Verify that the connector internal O-ring seals are in place, and then connect
2.
the TRANSMITTER interconnect cable of the starboard transducer array to
the TX-STBD connector on the Sonar Electronics; connect the RECEIVER
interconnect cable to the RX-STBD connector.
3. Connect the jumper cable (p/n 12900916-01) to the T/C connector on the Sonar
Electronics and to the Sonar Electronics Interface connector on the Sonar
Processor.
4. Connect a user supplied cable to the AUV Host and Deck Cable Interconnect
connector on the Sonar Processor and to the AUV host. Refer to Drawing
15104595 in APPENDIX A: "Drawings and Parts Lists," for the connector pinout
information.
Connecting the System Components
TRANSMITTER
RECEIVER
Transducer Array Connectors
3-5
Advertisement
Table of Contents
