ETC Source 4WRD Color Quick Manual page 4

ETC Quick Guide
Source 4WRD Color (CE) Version 1.0.0
1. Use oil-free canned air to clean the LED emitters before you install the
retrofit. Do not touch the LED emitters.
2. With the fixture resting securely on a flat surface, attach the supplied
threaded post to the back end of the fixture body. Use an adjustable
wrench to tighten the threaded post one-quarter turn past finger
tight.
3. Secure the earth bond wire to the fixture body using the provided
screw and washer.
4. Gently slide the Source 4WRD Color onto the fixture body and
threaded post while guiding the LED tower into the lamp housing
hole, as shown in the following image. Take care to prevent contact
between the LEDs and the reflector.
Source Four
fixture body
5. Use a #2 Phillips screwdriver to tighten the screw located on the back
end of the Source 4WRD Color, directly above the Z-adjustment knob.
6. Pull gently to verify secure attachment.
7. Set the Z-adjustment using the Z-adjustment knob. See
adjustment on page 8
Source 4WRD Color (CE)
Lamp
housing
hole
Insert threaded
post here
Secure earth
bond wire
.
Page 4 of 8
Tighten
screw
Z-adjustment
knob
Set the Z-
ETC