Remove Incandescent Lamp Housing; Install The Source 4Wrd Color Retrofit - ETC Source 4WRD Color Quick Manual

ETC Quick Guide
Source 4WRD Color (CE) Version 1.0.0

Remove Incandescent Lamp Housing

1. Unplug the Source Four incandescent fixture and place it on a flat,
stable surface.
2. Loosen the brass thumb screw located above the beam adjustment
knob. The lamp housing is now loose.
3. Slide the lamp housing away from the fixture body and locate the
screw that secures the earth bond wire to the fixture body. Loosen and
remove the screw and accompanying washer to free the earth bond
wire.
4. Remove the lamp housing from the fixture body.

Install the Source 4WRD Color Retrofit

WARNING:
onto luminaires that have the construction features and
dimensions shown in the images in this document and where the
input rating of the retrofit kit does not exceed the input rating
of the luminaire.
WARNING:
of wiring or electrical components during kit installation.
CAUTION:
other than oil-free canned air.
Tools required:
Adjustable wrench
•
#2 Phillips screwdriver
•
Source 4WRD Color (CE)
RISK OF FIRE OR ELECTRIC SHOCK! Install this kit only
Do not make or alter any open holes in an enclosure
Do not touch or clean LED emitters with anything
Page 3 of 8 ETC