Table of Contents
Advertisement
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[LEFT/RIGHT SWAP]
[PROJECTION METHOD]
[GEOMETRY]
[OSD POSITION]
4)
Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
[MAIN/SUB VERSION]
[NETWORK VERSION]
[INTAKE AIR TEMP.]
[EXHAUST AIR TEMP.]
[SELF TEST]
[INPUT]
[SIGNAL NAME]
[MEMORY NO.]
[BACKUP INPUT STATUS]
[NUMBER OF REGISTERED
SIGNAL]
[COOLING CONDITION]
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[REMOTE2 STATUS]
[AC VOLTAGE]
198 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input is SDI1 to SDI4 on the Interface Board
g The [DISPLAY OPTION] menu → [SLOT IN] → [SINGLE LINK SETTING] → [SDI1]/[SDI2]/
[SDI3]/[SDI4] → [SYSTEM SELECTOR]
g The [DISPLAY OPTION] menu → [SLOT IN] → [DUAL LINK SETTING] → [SYSTEM
SELECTOR]
f When the input is SDI OPT1 or SDI OPT2 on the Interface Board
g The [DISPLAY OPTION] menu → [SLOT IN] → [SDI OPT1]/[SDI OPT2] → [SYSTEM
SELECTOR]
f When the input is anything other than SDI/SDI OPT
The [PICTURE] menu → [SYSTEM SELECTOR]
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 109)
Temporarily pauses the image. (x page 165)
Displays the waveform of the input signal. (x page 165)
Loads the registered lens memory. (x page 170)
Switches the [LEFT/RIGHT SWAP] setting. (x page 130)
Switches the [PROJECTION METHOD] setting. (x page 167)
Switches the [GEOMETRY] setting. (x page 115)
Switches the [OSD POSITION] setting. (x page 158)
Displays the type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
Displays the main and sub versions of the firmware of the projector.
Displays the network version of the firmware of the projector.
Displays the intake air temperature status.
*1
Displays the exhaust air temperature status.
*1
Displays the self-diagnosis information.
Displays the input terminal currently selected.
Displays the representative input terminal when one image is displayed with multiple input signals.
Displays the input signal name.
Displays the memory number of the input signal.
Displays whether switching to the backup input signal is possible or not when [BACKUP INPUT
MODE] is set to [OFF]. (x page 137)
Displays the number of registered signals.
Displays the set cooling conditions.
Displays the control status of the REMOTE2.
Displays the input supply voltage.
Advertisement
Table of Contents
