Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Displaying internal test pattern
The projector has ten types of internal test patterns to check the condition of the projector. To display test patterns,
perform the following steps.
button
1)
Press the <TEST PATTERN> button.
2)
Press qw to select the test pattern.
Note
f Test patterns can also be displayed using the menu operation. Refer to "[TEST PATTERN] menu" (x page 206) for details.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.
Using the status function
Display the status of the projector.
button
1)
Press the <STATUS> button.
f The [STATUS] screen is displayed.
Note
f The projector status can also be displayed using the menu operation. Refer to the [PROJECTOR SETUP] menu → [STATUS]
(x page 198) for details.
Setting ID number of the remote control
When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using a single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, press the <ID
ALL> button on the remote control. Also, you can control a projector by pressing the <ID ALL> button on
the remote control even if you do not know the projector ID.
button
1)
Press the <ID SET> button on the remote control.
2)
Within five seconds, press and set the one-digit or two-digit ID number set on the projector body
using the number (<0> - <9>) buttons.
f If you press the <ID ALL> button, you can control the projectors regardless of the ID number setting of the
projector body.
STATUS
PROJECTOR TYPE
PT-RZ34K
SERIAL NUMBER
123456789012
PROJECTOR RUNTIME
10000h
LIGHT RUNTIME
10000h
CONTINUOUS LIGHTING TIME
1h 23m
MAIN/SUB VERSION
1.00 / 1.00
NETWORK VERSION
1.00
INTAKE AIR TEMP.
31°C/87°F
EXHAUST AIR TEMP.
31°C/87°F
SELF TEST
NO ERRORS
E-MAIL/USB
ENTER
CHANGE
EXIT
MENU
1/6
ENGLISH - 95
Advertisement
Table of Contents
