Table of Contents
Advertisement
Chapter 5 Operations — Using the information monitor function
[SHUTTER]
[OSD]
[IP ADDRESS(WIRED)]
*1 The representative input terminal is displayed when one image is displayed with multiple input signals.
[SETUP] menu
Set the information monitor to the menu operation mode by pressing the <INFO> button on the control panel.
For the operation of the menu, refer to "Basic operation procedure in the menu operation mode" (x page 262).
[ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1)
Press as to select [SETUP].
2)
Press the <ENTER> button.
f The sub-menu item is displayed.
3)
Press as to select [ID].
4)
Press the <ENTER> button.
f Setting in [PROJECTOR ID] is displayed.
5)
Press the <ENTER> button.
f Setting can be changed.
6)
Press qw to switch the setting item.
f The items will switch each time you press the button.
[ALL]
[1] - [64]
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
f If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting ID number of the remote control" (x page 95) for how to set the ID number on the remote control.
[INFO MONITOR]
Set the information monitor.
r Setting the display during normal status
Display/hide the information monitor during no operation.
1)
Press as to select [SETUP].
2)
Press the <ENTER> button.
f The sub-menu item is displayed.
3)
Press as to select [INFO MONITOR].
4)
Press the <ENTER> button.
f The detailed setting item is displayed.
5)
Press as to select [DEFAULT].
f The current setting is displayed.
6)
Press the <ENTER> button.
f Setting can be changed.
Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter function disabled)
Status of the on-screen display function ([ON]: Display; [OFF]: Hide)
IP address of the wired LAN
Select this item when controlling projectors without specifying an ID number.
Select this item when specifying an ID number to control individual projector.
ENGLISH - 263
Advertisement
Table of Contents
