Projected Image And Throw Distance - Panasonic DLP PT-RZ34K Operating Instructions Manual

Portrait setting and projecting forward
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
Note
f In the portrait setting, the on-screen menu is displayed sideways.
To display the on-screen menu vertically, change the [OSD ROTATION] setting in the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY]
(x page 158).
f The projector has a built-in angle sensor. The attitude of the projector is automatically detected by setting [FLOOR/CEILING] to [AUTO] in
the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
r Angle sensor
The range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.

Projected image and throw distance

Install the projector referring to the projected image size, projection distance, etc.
When the Zoom Lens (Model No.: ET-D3LEW200), the Fixed-focus Lens (Model No.: ET-D3LEU100,
ET-D75LE95), or the Fisheye Lens (Model No.: ET-D3LEF70) is used, the projection relation between the
screen and the projector differs from that of other lenses. For details, refer to "ET-D3LEU100, ET-D3LEW200"
(x page 43), "ET-D75LE95" (x page 44), or "ET-D3LEF70" (x page 45).
Attention
f Before setting up, read "Precautions for use" (x page 21).
f When the Fixed-focus Lens (Model No.: ET-D75LE95) is used, install the projector so that its back plane is parallel to the screen, making
the projected image rectangular.
The vertical keystone distortion in moderate range can be corrected with the [POSITION] menu → [GEOMETRY] → [KEYSTONE] →
[VERTICAL KEYSTONE] (x page 115) even after the projector is installed. For the range that can be corrected, refer to "[GEOMETRY]
projection range" (x page 47).
f Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
Chapter 2 Getting Started — Setting up
Setting value
[FRONT]
Set in accordance with the image
to project.
Floor standing installation
Floor standing installation
Projection direction
Portrait setting and projecting from the rear
(Using the translucent screen)
Menu item
[FRONT/REAR]
[FLOOR/CEILING]
30°
Ceiling mount installation
30°
Setting value
[REAR]
Set in accordance with the image
to project.
ENGLISH - 41