[Frame Delay]; [Frame Lock]; [Raster Position] - Panasonic DLP PT-RZ34K Operating Instructions Manual

[NORMAL]
[FAST]
*1
[FIXED]
*2
*1 [FAST] can be set when the input signal is the interlaced signal
*2 Only when moving image signals and still image signals with the vertical scanning frequency of 50 Hz or 60 Hz are input
Note
f When [FRAME RESPONSE] is set to [FAST], the [DIGITAL CINEMA REALITY] setting becomes disabled and is fixed to [OFF].

[FRAME DELAY]

Set the additional delay time against the frame delay status by the [FRAME RESPONSE] setting.
1) Press as to select [FRAME DELAY].
2) Press the <ENTER> button.
f The [FRAME DELAY] screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[+0.00ms] - [+100.00ms]
f The delay time (approximate) from the point the video signal is input until the image is projected is
displayed in [ACTUAL DELAY] of the [FRAME DELAY] screen.
Note
f When the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] → [MODE] is set to [SLAVE], [FRAME DELAY] cannot be set. In
such case, the projector will operate according to the [FRAME DELAY] setting of the projector where the [PROJECTOR SETUP] menu →
[MULTI PROJECTOR SYNC] → [MODE] is set to [MASTER].

[FRAME LOCK]

Set this function to display the image in 3D when the vertical scanning frequency of the signal is 25 Hz, 50 Hz,
and 100 Hz.
1) Press as to select [FRAME LOCK].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f [FRAME LOCK] is not displayed when a signal with the vertical scanning frequency other than the above is input or 2D images are
displayed.
f The image may flicker when [FRAME LOCK] is set to [ON].
f The displayed image may look discontinuous when [FRAME LOCK] is set to [OFF].

[RASTER POSITION]

This will allow the position of the image to move within the display area arbitrarily when the input image is not
using the whole display area.
1) Press as to select [RASTER POSITION].
2) Press the <ENTER> button.
f The [RASTER POSITION] screen is displayed.
3) Press asqw to adjust the position.
126 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Standard setting.
Simplifies the image processing to reduce image frame delay.
Sets image frame delay to be constant regardless of the image position or magnification.
Sets the delay in 0.01 ms increments.
Decreases the flickering of the displayed image.
Synchronizes the displayed image to the vertical scanning frequency of the input signal.