Table of Contents
Advertisement
maximum value that can be set.
12) Adjust [LIGHT OUTPUT] of each projector.
f Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness will be the same as the projector
with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f Brightness control starts.
Note
f Brightness is automatically corrected whenever the light source lights up by switching on/off the projector, etc.
f When the variation in brightness has increased due to aging of the light source, or when you replaced the light source, readjust the
brightness control.
[NO SIGNAL SETTING]
Set the operation of the function when there is no input signal.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
1)
Press as to select [NO SIGNAL SETTING].
2)
Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3)
Press as to select [BACKUP INPUT SETTING].
4)
Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
5)
Press as to select [BACKUP INPUT MODE].
6)
Press the <ENTER> button.
f The [BACKUP INPUT MODE] screen is displayed.
7)
Press as to select the combination of the input and press the <ENTER> button.
Primary input
[SDI]
[SDI]
[HDMI1 [SLOT]]
*1
[DVI-D1 [SLOT]]
*1
[SDI1 [SLOT]]
*1
*1 This is displayed when the optional Interface Board equipped with corresponding input is installed in <SLOT>.
8)
Press the <MENU> button.
f The [BACKUP INPUT SETTING] screen is displayed.
9)
Press as to select [AUTOMATIC SWITCHING].
f When [BACKUP INPUT MODE] is set to [OFF], [AUTOMATIC SWITCHING] cannot be selected.
10) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
[DISABLE]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Secondary input
[OFF]
[HDMI]
[DVI-D]
[HDMI2 [SLOT]]
*1
[DVI-D2 [SLOT]]
*1
[SDI3 [SLOT]]
*1
Switches to the secondary input (primary input) automatically when the input signal for primary input
(secondary input) is disrupted.
Disables the automatic input switching function.
Details
Disables the backup function.
Enables the backup function.
ENGLISH - 187
Advertisement
Table of Contents
