Installation; Upgrading The Memory And Compact Flash - AMX NetLinx NXP-TPI/4 Operation/Reference Manual

Installation

The NXP-TPI/4 is delivered from the factory with four installed input card covers (FIG. 4). The unit is
capable of supporting any combination of up to four TP4 input cards. The two different types of input
modules are the TP4-RGB and TP4-VID.
Input card covers
FIG. 4 Factory default NXP-TPI/4

Upgrading the Memory and Compact Flash

The TPI/4 unit is shipped with two default modules (an EXM memory module and a Compact Flash
card). Each module has a storage size of 64 MB.
These components are on the internal circuit board. ANY MEMORY UPGRADE
should be done after the removal of the factory installed card covers and
housing.
The best method of accessing the modules is to remove the outer TPI/4 housing,
replace the modules, then reinstall the housing. Refer to the Step 2: Removing the
Outer TPI/4 Housing section on page 10 for more details.
The Compact Flash card is factory programmed with specific TPI/4 firmware. These components can be
ordered from AMX in several different upgrade sizes (as listed in the following table):
Optional Module Upgrades
EXM Memory Module
NXA-EXM128M - 128 MB memory card
NXA-EXM256M - 256 MB memory card
Carefully remove the components from the shipping box. Refer to the Specifications table on page 2 for
more information on the unit and the available input cards.
NXP-TPI/4 NetLinx Touch Panel Interface
Round screws
Compact Flash
NXA-CFTPI128M - 128 MB compact flash card
NXA-CFTPI256M - 256 MB compact flash card
NXA-CFTPI512M - 512 MB compact flash card
NXA-CFTPI1G - 1 GB compact flash card
Installation
Flat-head screws
Housing screws
Grounding Bolt
9