AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 77

Protected Setup Page Elements (Cont.)
System Recovery:
FIG. 51 Protected Setup page-System Recovery confirmation dialog
Channel Port
Level Port
Channel Code
Number
FIG. 52 Button/slider Function Show example
NXP-TPI/4 NetLinx Touch Panel Interface
Allows you to either reset the TPI/4 to factory default settings and/or wipe out all
existing touch panel pages:
• The Reset System Settings button allows a user to wipe out all current
configuration parameters on the TPI/4 (such as IP Addresses, Device
Number assignments, Passwords, and other presets).
- Pressing this button launches a Confirmation dialog (FIG. 51) which asks
you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
• The Remove User Pages button allows you remove all current TPD4 touch
panel pages currently on the TPI/4 (including the pre-installed AMX Demo
pages).
- Pressing this button launches a Confirmation dialog (FIG. 51) which asks
you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES
button for 5 seconds. This delay provides an additional amount of time for
the user to confirm their decision.
Channel Code
Number
3,132 Address
Port
Button
2,8 3,50
Address Code
Number
Firmware Pages and Descriptions
You have a wait time of 5 seconds
before the YES option is enabled.
Channel Port
7,10
Slider
Level Port
4,9
1,8
Channel Code
Number
Channel Code
Number
Address
Port
Address Code
Number
71