AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 84

Programming
Page Commands (Cont.)
@CPG
Clear all popup
pages from
specified popup
group.
@DPG
Delete a specific
popup page from
specified popup
group if it exists.
@PDR
Set the popup
location reset flag.
@PHE
Set the hide effect
for the specified
popup page to the
named hide effect.
@PHP
Set the hide effect
position.
78
Syntax:
"'@CPG-<popup group>'"
Variable:
popup group = 1 - 50 ASCII characters. Name of the popup group.
Example:
SEND_COMMAND Panel,"'@CPG-Group1'"
Clears all popup pages from the popup group 'Group1'.
Syntax:
"'@DPG-<popup page name>;<popup group name>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the popup page.
popup group name = 1 - 50 ASCII characters. Name of the popup group.
Example:
SEND_COMMAND Panel,"'@DPG-Popup1;Group1'"
Deletes the popup page 'Popup1' from the popup group 'Group1'.
If the flag is set, the popup will return to its default location on show instead of its last drag
location.
Syntax:
"'@PDR-<popup page name>;<reset flag>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
reset flag = 1 = Enable reset flag
0 = Disable reset flag
Example:
SEND_COMMAND Panel,"'@PDR-Popup1'"
Popup1 will return to its default location when turned On.
Syntax:
"'@PHE-<popup page name>;<hide effect name>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
hide effect name = Refers to the popup effect names being used.
Example:
SEND_COMMAND Panel,"'@PHE-Popup1;Slide Left'"
Sets the Popup1 hide effect name to 'Slide Left'.
Only 1 coordinate is ever needed for an effect, however, the command will specify both.
This command sets the location at which the effect will end at.
Syntax:
"'@PHP-<popup page name>;<x coordinate>,<y coordinate>'"
Variable:
popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
Example:
SEND_COMMAND Panel,"'@PHP-Popup1;75,0'"
Sets the Popup1 hide effect x-coordinate value to 75 and the y-coordinate value to 0.
NXP-TPI/4 NetLinx Touch Panel Interface