AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 11

Specifications (Cont.)
Rear Panel Components
(Cont.):
PC control:
VGA output:
Ethernet 10/100 port:
Ethernet 10/100 LEDs:
ICSNet connectors:
Stereo Output connector:
PWR connector:
TP4 Input Cards:
TP4-VID:
TP4-RGB:
NXP-TPI/4 NetLinx Touch Panel Interface
• 2 PS/2 ports for Keyboard and Mouse control.
• 2 USB ports for Keyboard and Mouse control. The two Type-A USB ports can
connect up to two external keyboard or mouse devices for use with Virtual
PC applications.
- These ports can be used to communicate to a PC and transfer pass-thru
touch control from the external devices, thru the TPI/4, through the TP4-RGB
Type-B USB connection, to the target PC, and then back again.
• HD-15 VGA output connector with a maximum resolution of 1280 x 1024.
• RJ-45 port for 10/100 Mbps communication. The Ethernet port automatically
negotiates the connection speed (10 Mbps or 100 Mbps), and whether to use
half duplex or full duplex mode.
• This device communicates with the NetLinx Master using the ICSP protocol
over Ethernet. This communication is reflected via the front ICSP LED.
LEDs that show communication activity, connections, speeds, and mode
information:
• A-activity - Yellow LED lights when receiving Ethernet data packets.
• L-link - Green LED lights when the Ethernet cables are connected and
terminated correctly.
• Two RJ-45 connectors that allow connection to an ICSNet Hub.
• Stereo output through a 3.5mm mini-jack (for use with external speakers).
• 2-pin 3.5 mm mini-Phoenix connector.
• Refer to Appendix section on page 133 for more detailed power consumption
information.
Install the TP4-VID input module into any input slot to connect video sources,
such as VCRs and DVDs. Four screws secure the module.
• Accepts Composite or S-Video input signals for scalable video windows.
• Input video types are: NTSC, PAL, and SECAM.
• Composite LED indicator (turns On when composite video input is detected).
• S-Video LED indicator (turns On when S-Video input is detected).
• Connectors include:
- BNC Composite Video Input
- S-Video video input
Install the TP4-RGB input module into any input slot to connect RGB-type
sources such as VGA, SVGA, etc. Two black screws secure the module.
• Accepts RGBHV, RGBS (H/V), and RG
• Accepts computer-level graphics for scalable video windows.
• USB used for pass-through computer control.
- Pass-thru must be enabled to control devices on the RGB card when
other control devices are connected to the PS/2 and USB connectors on
the rear of the TPI/4 unit.
Refer to the commands in the ^KPS and ^MPS section on page 122.
• Connectors include:
- HD-15 D-Sub graphics input: This connector used to route an RGB
(computer) signal to a target monitor or panel by using the connected
TP4-RGB card.
- USB Mouse/Keyboard port: Type-B USB device port input connector
for pass-thru computer control (by connecting an external keyboard or
mouse device for use with different PC applications). The touch signal
information is sent to and from the PC via this two-way connector.
• Refer to the following Pixel Input field information for the supported
resolutions and refresh rates via the TP4-RGB card.
Product Information
B.
s
5