AMX NetLinx NXP-TPI/4 Operation/Reference Manual page 54

Upgrading TPI/4 Firmware
FIG. 33 Assigning Communication Settings and TCP/IP Settings
4. Click the Communications Settings button to open the Communications Settings dialog.
5. Click on the NetLinx Master radio button (from the Platform Selection section) to indicate that you
are working with a NetLinx Master (such as the NXC-ME260/64 or NI-Series of Integrated
Controllers).
6. Click on the Authentication Required radio box (if the Master is secured) and then enter a
username and password.
7. Click on the TCP/IP radio button (from the Transport Connection Option section) to indicate you
are connecting to the Master through an IP Address.
8. Click the Edit Settings button (on the Communications Settings dialog) to open the TCP/IP
Settings dialog (FIG. 33).
9. From within the TCP/IP dialog click New to enter the IP information for a new IP Address or select
from the list of previously entered IP Address and alter their properties by clicking the Edit button
and making your changes.
10. Enter the IP Address into the TCP/IP Address field. This information is obtained from either your
System Administrator or obtained from the Master.
11. Click OK when you are done adding or editing the IP Address from the New/Edit TCP/IP Setting
dialog.
12. Click OK three more times to close the open dialogs and save your settings.
13. Click Yes to interrupt the current communication from the Master and apply the new settings.
14. Select Tools > Reboot the Master Controller to access the Reboot the Master dialog, then click
Reboot to reboot the Master and incorporate any changes.
15. Once the dialog replies with "Reboot of system complete", press Done.
16. Click the OnLine Tree tab in the Workspace window to view the devices on the System. The default
System value is one.
17. Right-click on the Empty Device Tree/System entry and select Refresh System to re-populate the
list.
48
List of previously saved IP Addresses
NXP-TPI/4 NetLinx Touch Panel Interface