Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot Pearl v1.7
Safety
For professional use only. Read the entire manual before using this
equipment.
CAUTION:
•
•
WARNING:
allow it to cool before performing any cleaning and maintenance.
WARNING:
Luminaire suitable for use in emergency lighting applications in
accordance with 2017 National Electrical Code section 700.24
when used with an ETC DMX Emergency Bypass Controller.
Equipment intended for this purpose must be properly selected,
installed, and maintained so that facility conformance can be
obtained. Installation and servicing shall be performed by
qualified service personnel.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
Do not use outdoors.
•
Do not let power supply cords touch hot surfaces.
•
Do not mount near gas or electric heaters.
•
Equipment should be mounted in locations and at heights where it
•
will not readily be subjected to tampering by unauthorized
personnel.
The use of accessory equipment not recommended by the
•
manufacturer may cause an unsafe condition.
Do not use this equipment for other than intended use.
•
SAVE THESE INSTRUCTIONS
ColorSource Spot Pearl
Risk of eye injury. Do not stare directly into the light.
Do not operate in proximity to flammable materials.
Disconnect the fixture from power and DMX and
The ColorSource Spot Pearl is a Directly Controlled
Page 2 of 16
ETC
Advertisement
Table of Contents
