King gates JET XL 230 Installation And Use Instructions And Warnings page 19

04. Fix the bracket in place using suitable plugs, screws and washers
(not supplied)
3.5.2 Installation of the front fixing
–
bracket
01. For the installation of the front bracket to the gate leaf, refer to
distance D (fig. 2).
02. Define the front bracket installation height in accordance with
fig. 4;
03. Fix the bracket to the solid section of the gate leaf.
3.5.3 Securing the gearmotor to the
–
fixing brackets
•
Secure the gearmotor to the rear bracket:
Note: if the rear bracket is not completely level, the back tilting
section can help compensate for any axis misalignments
between the two brackets (+/-5°).
+ 5°
- 5°
01. Secure the gearmotor to the bracket as shown in fig. 6, using the
screw, washer and nut supplied;
02. Fully tighten the nut and then loosen it again by approximately
1/10 of a turn, to allow a minimum clearance between the parts.
1
Fig. 4
Fig. 5
2
Fig. 6
•
Secure the gearmotor to the front bracket:
01. Secure the gearmotor to the bracket as shown in fig. 7, using the
screw and the washer supplied;
1
02. Fully tighten the screw;
• JET XL
Adjust the gearmotor opening and closing strokes:
01. Release the gearmotor as shown in fig. 8;
1
2
02. Remove the 2 screws underneath the handle and remove the
cover as shown in fig. 9.
1
2
3
Fig. 7
3
4
Fig. 8
2
Fig. 9
5