Mitsubishi Electric MELSEC iQ-F Series User Manual page 56

Item
I-Am send setting
Device restart
procedure setting
Time synchronization setting
6 PARAMETER SETTINGS
54
6.3 Basic Settings
Description
Send control Set whether or not to send I-Am only when the device is set to
Operational.
Send I-Am when the Set whether or not to send I-Am when the device status changes to
status changes to Operational.
Operational.
Enable/disable fixed- Set whether or not to send I-Am at a fixed-cycle.
cycle send
Fixed-cycle send Set the interval (second) for sending I-Am. (Available when the
interval (second) enable/disable fixed-cycle send is set to Enable)
I-Am response setting Set how to send I-Am and I-Have for Who-Is and Who-Has.
I-Am send setting Set how to send the spontaneous I-Am.
Device restart Set the device restart procedure.
procedure
Notification destination Set a network number to which notification is sent at device restart.
network number (Available when device restart is set to "Support")
Notification destination Set the IPv4 address to which notification is sent at device restart.
IP address (Available when device restart is set to "Support")
Notification destination Set a port number to which notification is sent at device restart.
port number (Available when device restart is set to "Support")
Set the response for receiving wild card.
Setting range
• Send I-Am only at the
Operational status.
• Send I-Am even at other
statuses than Operational.
(Default: Send I-Am only at the
Operational status.)
• Send
• Do not send
(Default: Send)
• Disable
• Enable
(Default: Disable)
1 to 4095
(Default: 60)
• RemoteBroadcast
• GlobalBroadcast
• LocalBroadcast
• Unicast
(Default: LocalBroadcast)
• LocalBroadcast
• GlobalBroadcast
(Default: LocalBroadcast)
• Do not support
• Support
(Default: Do not support)
0 to 65534
(Default: 0)
0.0.0.1 to 223.255.255.254
(Default: 192.168.0.254)
0 to 65535
(Default: 47808)
• Ignore
• Output to the buffer memory
(Default: Ignore)